![]() At the command prompt, type regsvr32 Initpki.dll /s, and then press ENTER. At the command prompt, type regsvr32 Wintrust.dll /s, and then press ENTER. At the command prompt, type regsvr32 Softpub.dll /s, and then press ENTER. Click Start, click Run, type cmd, and then click OK. To register these files, follow these steps: 1. NOT!): " To fix this, register the Softpub.dll, Wintrust.dll, Initpki.dll, and Mssip32.dll files. It seems there were some Windows security files unregistered (thanks Microsoft. After more research based on your link I found the below solution worked for me. Any advice? This project has taken too long already so I'd rather not buy another device and wait again, but I feel like I may have no choice at this point. This was supposed to be able to do ICSP, and now I find out that it's only on a handful of chips. This has been done before by a colleague with a REVELPROG (which is not available to me and costs 3x as much) so I know that the drive board will allow it. I feel like I bought the wrong device and wasted my money. If I select a similar-sounding ATMEL chip just to play, I either get no warning/all zeroes, no id, or an overcurrent error. The ICSP port is disabled when the correct chip is selected, and it no id/all zeroes when I just put the wires in the appropriate places in the ZIF. I have a TL866A and I connected wires to the appropriate solder points to hit the chip and connected them to the ZIF (quite the trick, that!) and also the ICSP port. I need to clone the drive parameters from one hard drive to another. Since this seems to have become the TL866x chat room, and all the great minds seem to be here, I'll ask here. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |